Case Maxxum 115, 125, 135, 145, 150, Tier 4B Tractor Operator's Manual
452 pages · Publication 48039742
Added to your cart. View cart
- Models
- Maxxum 115, 125, 135, 145, 150, Tier 4B
- Manual type
- Operator's Manual
- Pages
- 452
- Publication
- 48039742
- Condition
- Brand new
What's inside
From the manual's own table of contents: 42 sections, 269 entries. See sample pages (PDF, 654 KB)
Show all 42 sections
Instructor's seat68 topics
- Introduction
- Cab air filters
- In cab storage (where fitted)
- Cable and wiring routing
- Mobile telephone usage
- Implement monitor installation
- Cab air pressurisation control (where fitted)
- Operator's seat
- Air suspension seat
- Air suspension seat deluxe
- Air suspension seat with passive or Dynamic Damping System (DDS)
- Seat belt
- Instructional seat
- Ignition key
- Hazard light switch
- Lights and turn indicator lever
- Follow me home lights
- Windshield wiper and washer controls
- Clutch pedal
- Foot throttle pedal
- Hand throttle
- Foot brakes
- Steering column
- Hand brake
- Switch panel
- Switches on C-pillar
- Hydraulic master switch
- Fast steering system (where fitted)
- Battery isolator control switch
- Climate controls
- Manual temperature control
- Automatic Temperature Control (ATC)
- Switch panel
- Left-hand and right-hand outermost work light switch
- Interior light
- Analog Digital Instrument Cluster (ADIC)
- Gauges
- Indicator and warning lights
- Displays
- Keypad enhanced
- Selecting or changing the display settings
- Ground speed calibration
- Performance monitor
- Alarm functions
- Accessing stored fault codes
- Selective Catalytic Reduction (SCR) exhaust treatment - Overview
- Warning and advisory symbols
- Refueling the tractor
- Starting the engine
- Grid heater cold start aid (where fitted)
- Fuel heater (where fitted)
- Coolant immersion heater (where fitted)
- Transmission oil heater (where fitted)
- Boosting the battery
- Stopping the engine
- Automatic engine shut down
- Automatic engine shut down with enhanced keypad (where fitted)
- Operating in cold temperatures
- Low idle speed management
- Carrying the tractor on a transporter
- Secure the high visibility roof panel
- Freeing a stuck tractor
- Towing the tractor
- Variable engine power management
- Constant engine speed
- Differential lock
- Four wheel drive
- Front axle suspension (where fitted)
HTS standard159 topics
- Quick guide
- Explanation of symbols
- Recording and replaying
- Recording a sequence
- Replaying a sequence
- Shuttle lever
- Sharp shuttle setting
- Transmission operation
- Transmission display
- Shuttle mode
- Driving the tractor
- Auto take off
- Speed matching
- Auto shift function
- Auto shifting field mode
- Auto shifting in road mode
- Creeper gears
- Fault codes
- Power Take-Off (PTO) operating precautions
- Changing the PTO output shaft
- Attaching PTO driven equipment
- Power Take-Off (PTO) operation
- Two speed PTO systems
- External PTO controls
- Auto PTO operation
- Power Take-Off (PTO) operation
- Electronic Draft Control (EDC)
- Electronic Draft Control (EDC) operation
- External hitch controls
- Settings and adjustments
- Hitch operation
- Auxiliary front couplers (where fitted)
- External hitch controls
- Remote control valves
- Connecting remote cylinders
- Operating with remote valves
- Hydraulic oil level when using remote hydraulic equipment
- Hydraulic power beyond for external services
- Attaching three-point hitch equipment
- Lift rod adjustment
- Top link adjustment
- Flexible link end adjustment
- Quick hitch
- Linkage stabilizer adjustment
- Drawbars and towing attachments
- Swinging drawbar
- Air-operated trailer brakes
- Trailer brake bias control
- Auxiliary air supply connector (where fitted)
- Hydraulic trailer brakes
- Front wheel track adjustment (two wheel drive)
- Front wheel track adjustment (four wheel drive)
- Front wheel alignment (two wheel drive)
- Front wheel alignment (four wheel drive)
- Steering stops
- Front axle oscillation stops
- Front fender
- REAR WHEEL TRACK ADJUSTMENT
- Flange type axle (where fitted)
- Bar type axle (where fitted)
- Dual rear wheels (where fitted)
- Ballasting and tires
- Iron weights (where fitted)
- Liquid ballast
- Tire inflation
- Tire pressures and permissible loads
- Diagnostic socket
- Trailer socket electrical
- ELECTRICAL POWER CONNECTORS
- Internal power connectors
- External power connectors
- ISO bus classes
- Introduction
- Fuel requirement - Diesel fuel
- Fuel - Storage, handling and transport
- Biodiesel fuel - Biodiesel fuels
- Change the engine oil
- Protective devices
- Tractor jacking points
- Lubricants and coolants
- General specifications
- Capacities
- Organic Acid Technology (OAT) coolant
- Maintenance chart
- Change the engine air cleaner outer element
- Drain the fuel system water separator
- Check the battery fluid level
- Check the engine coolant level
- Check the engine oil level
- Check the remote control valve drain bottles
- Check windscreen washer reservoir
- Drain air reservoir on air operated trailer brake
- Service operations
- Clean the cab air filter
- Clean the cooler section
- All grease fittings
- Check the front and the rear wheel nuts
- Check the tire pressures and the tire condition
- Inspect the poly V-belt
- Inspect the compressor drive belt
- Check the battery fluid level
- Adjust the hand brake
- Check the transmission oil level, the rear axle oil level and the hydraulic oil level
- Check the 4WD front axle differential oil level and the hubs oil level
- Check the front PTO gearbox oil level
- Change engine oil and filter
- Change the first stage fuel filter and the fuel filter element
- Change the engine air cleaner outer element
- Change the charge pump oil filter
- Check the engine air intake connections
- Check the transmission oil cooler pipe couplings
- Clean the DEF/AdBlue in-line filter
- Change the cab air filters
- Change the hydraulic suction pump oil filter
- Change the 4WD differential oil
- Change the 4WD planetary hub oil
- Change the front PTO gearbox oil
- Grease the rear axle shaft bearing
- Change the engine air cleaner inner element
- Check the valve tappet clearance
- Change the DEF/AdBlue in-line filter
- Change the air brake drier reservoir
- Change the poly V-belts
- Change the transmission oil, the rear axle oil and the hydraulic oil
- Change the air conditioning receiver drier
- Change the engine breather filter
- Change the DEF/AdBlue main filter
- Change the engine coolant fluid
- Cleaning the tractor
- Check first stage fuel filter and water trap
- Bleeding the fuel system
- Hydraulic system hoses
- Check the brake pedal latching/unlatching
- Adjust the automatic pickup hitch
- Headlight adjustment
- Work light adjustment
- Bulb replacement
- Fuses and relays
- Protecting the electronic and electrical systems during battery charging or welding
- Battery removal and installation
- Tractor storage
- Preparation for use after storage
- Introduction
- General dimensions
- Minimum turn radius
- Axle dimension
- Maximum operating angle
- Maximum tractor operating weights
- Tractor weights
- Capacities
- Engine
- Fuel system
- Air cleaner system
- Cooling system
- Transmission
- Rear Power Take-Off (PTO)
- Front Power Take-Off (PTO)
- Three-point hitch
- Three-point hitch front
Inside this manual
Real pages from this operator's manual (452 pages). Open the sample pages (PDF, 653 KB)
- Controls and operation, page 225: Auto PTO operation
- Specifications, page 309: Iron weights (where fitted)
- Maintenance, page 369: 7 - MAINTENANCE
- Color page: 2 - SAFETY INFORMATION
- Foldout diagram: 3 - CONTROLS AND INSTRUMENTS
Other manuals for this machine
Save 10% on 2 manuals, 15% on 3 or more. Other manuals are listed below. Editions cover different serial number ranges: check the serial coverage and tick only the ones that match your machine.
Added to your cart. View cart
This is an operator's manual
Here's how it compares to the other manual types.
Service manual
Factory repair procedures and technical information such as specifications, troubleshooting, and wiring and hydraulic diagrams, for the models and systems the manual covers. See What's inside for its topics.
Operator's manual
Safe operation, controls, maintenance schedules, lubrication points, inspections, and basic checks. Repair procedures are in the service manual.
Parts manual
Illustrated diagrams with factory part numbers for identifying components and ordering parts. Repair procedures are in the service manual.
What it's used for
Factory manual for in-house farm and construction shop use. Straightforward, complete, and easy to follow. It contains the OEM information dealership service departments and parts counters use to diagnose problems, identify components, and perform maintenance or repairs correctly.
Service shops and owner/operators who repair their own equipment
Identifying correct parts and seeing how assemblies come apart and go back together
Keeping equipment running with less downtime
Factory manual, 452 pages
Quantity one is the manual described above.
Fast free USA shipping
Ships in 1 business day.
60-day returns
Free if the mistake is ours. A manual ordered in error must come back unopened in its shrink-wrap; you pay return shipping and a 20% restocking fee applies. Return policy
Binder not included
Manuals over about 300 pages may need a standard 3-ring binder, which you can buy locally to keep the pages organized for shop use.
Other editions and similar models
Questions about model, serial number, engine coverage or contents? Contact us before purchasing and we'll help confirm it's the right manual. Please verify the manual type, machine model, serial number range and engine coverage before purchasing: manuals ordered in error carry a 20% restocking fee (return policy).